Plasti Dip Can & Spray Supplier - Peelable Rubber Coating (2024)

The 14.5 oz. liquid can will cover approximately 5 sq. ft. at 10 mils thickness. The 11 oz. spray will cover about 6 sq. ft. at 5 mils thickness.

Plasti Dip protective coating has a satin finish. If you are experiencing a cloudy or hazy finish, it’s likely caused by high humidity. Avoid these conditions or add approximately 5-10% naphtha to reduce the problem.

Dipping and removing too quickly can cause this. Remove at a rate of 1” every 5 seconds. If experiencing runs or sags when spraying, move can further away from the surface and apply a lighter coat. Sagging and dripping can also be caused by high humidity, high temperatures, windy conditions, or direct sunlight. Ideal conditions are low humidity, 70 degrees, little to no air movement in a well-ventilated area.

Most items being dip coated do not require priming because the coating is shrinking around the item as it dries. However, in extreme conditions or when adding protective coating to a large metal surface, primer is recommended. Use Plasti Dip Primeror a high quality acrylic auto body-type primer. Do not use Rust-Oleum® primer as it is not compatible.

Plasti Dip does not contain any heavy metals, and when completely dry, is considered harmless. However, it is not recommended that it be used on items that may be chewed or inserted into the mouth as it may present a choking hazard.

When following the directions, you can apply as many coats of Plasti Dip protective coating as you like. In most uses 10-12 mils thickness is adequate (2 dip coats, 3-4 brush coats, 4-5 spray coats). Greater thickness might be necessary for aesthetic reasons or in extreme cases.

Mixing different colors of Plasti Dip protective coating can be done to achieve other colors. Your local hardware, home center, or paint store may also sell tubes of tinting colors. Add approximately 1/3 of a 1 oz. tube per 14.5 oz. can of Plasti Dip.

While Plasti Dip has been used for dishwasher rack repair in the past, it is not recommended. OurReRACK™ product is much better suited for this application and works very well.

Plasti Dip protective coating has excellent resistance to acids, alkaline, and most common household chemicals. However, it is best to test this before going ahead with your application. Plasti Dip does have limited resistance to petroleum-based products.

While Plasti Dip has excellent dielectric properties (insulates against shock), ourLiquid Tape Electricalproduct is specifically formulated and conveniently packaged for this application.

Rub acetone or fingernail polish remover in an inconspicuous area and apply Plasti Dip to test for success.

Plasti Dip does not contain any polyvinylchloride or any other vinyl resins.

Yes, the Plasti Dip Enhancer in the Glossifier™ formulation provides a glossy finish on cured Plasti Dipped items. Plasti Dip Enhancers are formulated to bond only with the unique chemical structure of Plasti Dip and are not recommended for use on other surfaces.